The silicon steel sheet manufacturer is not really satisfied with the silicon content in very thin silicon steel cores. In terms of scale, the silicon content in very thin steel cores does not have a significant impact on the quality of direct transformers in practice. However, due to its directionality and non directionality, it has a good relationship with the basic model practice.

On the other hand, in fact, we have also found that the same type of very thin silicon steel core is not good, because if it is our own process, the difference in quality is even greater in practice. The difference is that, due to that difference, I noticed that sometimes it may reach 40% or 50%.

In fact, we still need to be careful. For excellent heat treatment, for the same material, the heat treatment and surrounding process are very thin, and the silicon core is good. This is actually very important. In practice, a very small 10mA driver current can directly reach 15000 Gauss, but in practice, it can reach 15000 Gauss, which corresponds to an encouraging current of 50mA. This is necessary, and the distance between the two is very large.

From a professional perspective of confirming the quality of the center, due to the thin silicon steel core, there are several parameters in practice, such as excitation current and iron loss, saturation parameter, etc.

On the other hand, there is a high demand for dislocation heads that connect very thin silicon steel cores. In this regard, we realize that in this case, in the event of a fracture, in practice, this will be a very thin silicon point attached to the magnetic flux leakage point at the steel core, which is a fact and does not need to exceed 23, that's good.

Article source: Silicon steel sheet manufacturerhttp://www.cheungshun.com